Thermogravimetric analysis for rapid assessment of moisture diffusivity in polydisperse powder and thin film matrices.

Accurate description of moisture diffusivity is key to precisely understand and predict moisture transfer behaviour in a matrix. Unfortunately, measuring moisture diffusivity is not trivial, especially at low moisture values and/or elevated temperatures. This paper presents a novel experimental procedure to accurately measure moisture diffusivity based on thermogravimetric approach. The procedure is capable to measure diffusivity even at elevated temperatures (>70°C) and low moisture values (>1%). Diffusivity was extracted from experimental data based on "regular regime approach". The approach was tailored to determine diffusivity from thin film and from poly-dispersed powdered samples. Subsequently, measured diffusivity was validated by comparing to available literature data, showing good agreement. Ability of this approach to accurately measure diffusivity at a wider range of temperatures provides better insight on temperature dependency of diffusivity. Thus, this approach can be crucial to ensure good accuracy of moisture transfer description/prediction especially when involving elevated temperatures.

Population changes in a biofilm reactor for phosphorus removal as evidenced by the use of FISH.

Induction of denitrification was investigated for a lab-scale phosphate removing biofilm reactor where oxygen was replaced with nitrate as the electron acceptor. Acetate was used as the carbon source. The original biofilm (acclimatised with oxygen) was taken from a well-established large-scale reactor. During the first run, a decrease in the denitrifying bio-P activity was observed after 1 month following a change in the anaerobic phase length. This was initially interpreted as a shift in the microbial population caused by the changed operation. In the second run, biomass samples were regularly collected and analysed by fluorescent in situ hybridisation (FISH) and confocal laser scanning microscopy (CLSM). Concurrently, samples were taken from the original reactor with oxygen as electron acceptor in order to investigate natural microbial fluctuations. A similar decrease in the activity as in the first run was seen after one month, although the phase lengths had not been varied. Hence, the decrease after 1 month in the first and second run should be seen as a start-up phenomenon. FISH could detect a noticeable shift in the microbial population mainly within the first 2 weeks of operation. Almost all bacteria belonging to the alpha subclass disappeared and characteristic clusters of the beta and gamma subclasses were lost. Small clusters of gram-positive bacteria with a high DNA G + C content (GPBHGC) were gradually replaced by filamentous GPBHGC. Most of the bacteria in the denitrifying, phosphate removing biofilm belonged to the beta subclass of Proteobacteria. The applied set of gene probes had been selected based on existing literature on biological phosphate removing organisms and included a recently published probe for a Rhodocyclus-like clone. However, none of the specific probes hybridised to the dominant bacterial groups in the reactors investigated. No noticeable changes were detected in the aerobic bench-scale reactor during this period, indicating that the observed changes in the lab-scale reactor were caused by the changed environment.